Mechanical Part

05 GM Full Size Truck TAC Module and PedalLS swap DBW set up, came of a 05 LM7. Re

moved to convert a 03+ LM7 to a red/blue DBC PCM and harness. Worked perfectly when pulled.

Mandan, ND

$80 OBO

2024-09-22 12:15:17

Five inch diesel exhaust muffler.

Brand new. Never used Flow through design. Cuts down on drone sound common with five inch systems.

Mandan, ND

$20 OBO

2024-09-21 00:19:44

6 Photos

GM transmission. Dont know much about it and just dont need it.

GM transmission. Don’t know much about it and just don’t need it.

Mandan, ND

$100 OBO

2024-09-14 07:22:25

1957 corvette intake manifold 3731398

Originally on a 283, fits Chevy small block

Mandan, ND

$100 OBO

2024-09-13 21:53:45

2006 Chevy Colorado transfer case with shift motor.

Sold the truck so no need for this. Asking $100.

Mandan, ND

$100

2024-09-09 09:42:21

Brand new still in the box right and left lower control arms with ball joints for

a 2006 Jeep Grand Cherokee, Selling because I didn't need them Call Joe at 701-202-0516

Mandan, ND

$75 OBO

2024-09-07 16:10:16

Old ford flathead headsI'm told

Mandan, ND

2 old ford flathead radiatorsI'm told, I do not know for sure what they are

2024-09-07 16:04:25

4 Photos

Mandan, ND

2024-09-07 15:51:24

Original offset carb sbf edelbrock torker 289 intake

Mandan, ND

2024-09-07 07:40:51

I had this cleaned and crack checked and was good. Needs 3 sleeves, has light surface rust since pictures were taken. I have other parts of it for sale as well just ask me what

1969 Ford 351w block

Mandan, ND

2024-09-07 07:40:39

1967-73 Ford Mustang 8 inch Rear Differential Housing

Bare 8 inch mustang rear end housing. 55 13/16 inches wide to outside of flanges. Leaf spring perches are about 43 1/8 inches on center. Nice

Mandan, ND

$125

2024-09-06 04:22:08

Eaton posi for GM 14 bolt 10.5" rear end

Basically new, maybe a few thousand miles on it, worked perfectly, only selling because it's extra after doing some rear end work. Stored in original packaging

Mandan, ND

$600 OBO

2024-09-02 13:09:45

16 QT oil drain pan

Drain pan and oil storage unit. Everything works (seals & caps) Oil filter wrench included Please text if interested

Mandan, ND

$15

2024-09-02 13:09:28

Oil drain pan for motorcycles

Oil pan for motorcycles Low profile oil pan for draining and storage of oil for transporting. In excellent condition. Works well plus seals and caps are good. Please text if interested.

Mandan, ND

$15

2024-08-30 16:09:24

Good Garrett Turbo.

Came off of a 7.3 to go bigger. Make an offer

Mandan, ND

Mopar 440 crank. Ready to run $300

2024-08-29 21:27:59

Mandan, ND

$300

2024-08-29 04:07:02

4 Photos

Muncie transmission.

M20 Looks good inside.

Mandan, ND

$1,465

2024-08-27 22:00:23

SBC Fuel pump $15 obo

Mandan, ND

$15 OBO

2024-08-23 00:49:26

Complete Set-up Edelbrock Victor 454-R Rectangular Port Manifold

Single Plane with Holley Dominator Carb Part #8896-1 4500 Series with Super Sucker Carb Spacer Carb has been bench flowed. Great

Mandan, ND

$1,200 OBO

2024-08-15 00:44:58

Tachometer

Mallory tachometer $35 obo

Mandan, ND

$35 OBO

2024-08-02 10:34:43

2015-2024 Mustang Coilover Set

Pedders eXtreme XA Coilover Kit with Camber Plates Ordered these July of 2023 and used them for about 2000 miles before removing to sell them car. You can see all

Mandan, ND

$700

2024-08-02 00:29:22

Ball Joint Spacers

One inch spacers for Chevy half ton 1973 - 87. Should fit half ton Blazers Suburbans and vans. New in box. Cash only.

Mandan, ND

$50

2024-08-02 00:29:21

R-12

Six full cans, one partial can with fill hose. Cash only.

Mandan, ND

$200

2024-07-30 14:13:53

Magnetos for stationary engines

Mandan, ND

$150

2024-07-12 13:41:43